Albatron K8-X800 ProII Driver
Specs: Albatron K8X Pro II AMD Athlon64 + Retail Crucial 2X MB PC DDR SDRAM Hercules ATI Radeon Pro MB. K8X ProII Albatron Motherboard mainboard chipset základní desky Slot Socket information. Besides, Albatron completes this board with an external panel with audio Quality of the audio section of the Albatron K8X Pro II yields (comparing only to.
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Regsitration Required]|
Albatron K8-X800 ProII Driver
As a spin-off of Giga-Byte, they have some of the same features, and go after the same enthusiast market. They have made some of the best overclocking GeForce 4 Ti cards, but does this socket board stack up to the example set before it? This is a standard arrangement, even though there is very Albatron K8-X800 ProII going on in that NB.
In this architecture however, that memory Albatron K8-X800 ProII has been moved on board the Athlon 64 processor.
Typically, this has been a weak point for VIA, but thanks to AMD, it's no longer much of a concern for them; with the Albatron K8-X800 ProII controller moved, the north bridge no longer has a lot to do. Right behind all of that are the three phase power regulation circuitry and the 12V power connector.
Maximum PC - Google Libros
Having Albatron K8-X800 ProII connector there is not the best for cable routing. Assuming that the VRM uses the 12V line to transform down to the 1. This helps keep the losses and variation down, which increase with distance. Still along the top of the board, at the center line is the CPU socket.
As you can see, AMD has Albatron K8-X800 ProII a heat sink retention frame similar to the one used by Intel on all P4 boards. This is a step in the right direction, after the continued reliance on socket lugs in the SocketA platform.
It leaves sufficient room in the area for large heat sinks and waterblocks. The only negative I can see is that by using only two holes it might be hard to get a waterblock to balance correctly on the CPU.
I have issues with the placement of Albatron K8-X800 ProII DIMM slots. They really cannot be put any higher up on the board, but by being so far from the side, even a small graphics card like the Radeon I use will prevent you from installing RAM with it in there. As a tradeoff however, the ATX and ATA connectors are placed nicely on the edge of the board, allowing those cables to be routed easily out of the main case airflow.
VIA K8T Based Mainboards Roundup This high-end board has a weighty set of accessories, good functionality including a normal audio controller based on VIA's chip, that is why Albatron K8-X800 ProII board supports an 8-channel audio-outand delivers a wide range Albatron K8-X800 ProII overclocking settings. The layout is standard and pretty convenient, though it might be difficult to hook up cables to the connectors near the left edge.
Also, it's not convenient to have the audio connectors in front of the PCI slots the cables will stretch along the whole PC case ; finally, a video card inserted may lock memory modules. It can be difficult to reach some jumpers when the board is already installed.