DRIVER: ADLINK CPCI-7841

CPCI ADLINK Technology Interface Modules DUAL-PORT ISOLATED CAN INTERFACE CARD datasheet, inventory, & pricing. Adlink PCI/cPCI card - Adlink PCI/cPCI SE card (it's a slight modification of previous card). Headquartered in Taiwan, ADLINK has operations in America, Singapore, Beijing, 3U CompactPCI Adapter, 8 DAC, 4DI, 4DO Board, rear I/O cPCI

F OFF 1: The jumper setting is specified as below: Be aware that there is no other add-on cards sharing the same interrupt ADLINK cPCI-7841 in the system.

Acceptance Code for CAN controller. Acceptance Mask for CAN controller.

• Welcome to
• Adlink Technology Parts Numbers List – AFR Enterprises
• Caninstallevent – ADLINK PCI-7841/cPCI-7841 User Manual
• Manual Rev. 3.00

Baud rate setting for the CAN controller. It is used by the CanGetPortStatus functions.

ADLINK cPCI-7841 ID field bit unsigned integer rtr: Length of data field. Data 8 bytes maximum time: Reserved for future use reserved: It is widely used by the DeviceNet layer functions. Address of destination.

Address of source. Message ID of DeviceNet packet len: Memory Mapping Range Return Value A bit unsigned integer High byte is the major version Low ADLINK cPCI-7841 is the major version Remarks Call this function to retrieve ADLINK cPCI-7841 version of current using driver.

This function ADLINK cPCI-7841 for your program to get the version of library and dynamic-linked library. Under DOS operation system, you will receive 1 if there is not enough memory.

Adlink cPCI Dual-port Isolated CAN Interface Card I01

If writing program for the Windows system. It will return -1, if ADLINK cPCI-7841 want to open a port had been opened.

And you must use CanCloseDriver to close the port after using. The properties of a CAN port such as baud rate, acceptance code, acceptance mask, operate mode. After configuration ADLINK cPCI-7841 over, the port is ready to send and receive data.

The function performs an algorithm to detect your baud rate. It needs that there are activities on the network.

And it will return a 1 when detecting no activity on the network or time was exceeded. Any packet on the network that can induce a interrupt on your computer. If that packet can pass your acceptance ADLINK cPCI-7841 and acceptance mask setting.

So if your program ADLINK cPCI-7841 t want to be disturbed. Actually, this function copies the data to the sending queue.